[ale] Priting issue

[cfowler at outpostsentinel.com (Christopher Fowler)]

I'm now faced with a printing problem after FC6 -> FC7.
I've had my Samsung ML-2010 working in FC3 and in FC6.  I've now tried
in FC7 and it seems like hald has gone stupid with this device

In kernel log I see this:

usb 1-1: USB disconnect, address 7
drivers/usb/class/usblp.c: usblp0: removed
usb 1-1: new full speed USB device using ohci_hcd and address 8
usb 1-1: configuration #1 chosen from 1 choice
drivers/usb/class/usblp.c: usblp0: USB Bidirectional printer dev 8 if 0
alt 0 proto 2 vid 0x04E8 pid 0x326C
usb 1-1: USB disconnect, address 8
drivers/usb/class/usblp.c: usblp0: removed
usb 1-1: new full speed USB device using ohci_hcd and address 9
usb 1-1: configuration #1 chosen from 1 choice
drivers/usb/class/usblp.c: usblp0: USB Bidirectional printer dev 9 if 0
alt 0 proto 2 vid 0x04E8 pid 0x326C
agpgart: Found an AGP 3.0 compliant device at 0000:00:00.0.
agpgart: Putting AGP V3 device at 0000:00:00.0 into 8x mode
agpgart: Putting AGP V3 device at 0000:02:00.0 into 8x mode
usb 1-1: USB disconnect, address 9
drivers/usb/class/usblp.c: usblp0: removed
usb 1-1: new full speed USB device using ohci_hcd and address 10
usb 1-1: configuration #1 chosen from 1 choice
drivers/usb/class/usblp.c: usblp0: USB Bidirectional printer dev 10 if 0
alt 0 proto 2 vid 0x04E8 pid 0x326C


And it keeps going and going repeating...

I've not even touched the cable or the printer.