[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[ale] Configure serial port settings at boot
- Subject: [ale] Configure serial port settings at boot
- From: jdp at algoloma.com (JD)
- Date: Sat, 06 Dec 2014 05:49:37 -0500
- In-reply-to: <[email protected]>
- References: <[email protected]>
On 12/05/2014 08:32 PM, Alex Carver wrote:
> Does anyone happen to know if there's a way to set up the default state
> of a serial port at boot? I want to switch the port into raw mode
> instead of cooked. When everything is running I just use "stty -F
> /dev/ttyS0 raw" but that will not survive a reboot.
>
> setserial as far as I can tell only handles the base configuration
> (address, IRQ, etc.)
Don't know, but perhaps a udev rule?