[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[ale] HOW2 install BellSouth DSL with a USB link rather than Ethernet ?
- Subject: [ale] HOW2 install BellSouth DSL with a USB link rather than Ethernet ?
- From: jimpop at yahoo.com (Jim Popovitch)
- Date: Sat, 30 Sep 2006 12:41:22 -0400
- In-reply-to: <[email protected]>
- References: <002501c6e461$2d693cb0$6a28a8c0@SAMBA> <[email protected]> <[email protected]>
On Sat, 2006-09-30 at 11:04 -0400, Ben Coleman wrote:
> If the Westell is configured to do PPPOE itself and operating as a NATting
> router (which I believe is the default configuration from BellSouth), yes,
> this should do fine. If it's set up in bridged mode (where the attached
> computer needs to run PPPOE), it may be another story.
When I tested BellSouth's DSL a while back, the Westel I received was in
bridge mode and had to be changed into router mode. Once I did that
(instructions are included in the Westel manual) I could log into the
Westel and configure the PPPoE params.
-Jim P.