[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[no subject]



GET RID OF THE DRIVE!!!!! See below

> 
> ----------------------------
> $ sudo smartctl -a /dev/hda
> smartctl version 5.32 Copyright (C) 2002-4 Bruce Allen
&gt; Home page is <a  rel="nofollow" href="http://smartmontools.sourceforge.net/";>http://smartmontools.sourceforge.net/</a>
&gt; 
&gt; === START OF INFORMATION SECTION ===
&gt; Device Model:     ST3120026A
&gt; Serial Number:    5JT5H6NQ
&gt; Firmware Version: 8.01
&gt; Device is:        In smartctl database [for details use: -P show]
&gt; ATA Version is:   6
&gt; ATA Standard is:  ATA/ATAPI-6 T13 1410D revision 2
&gt; Local Time is:    Sun Jun  5 20:10:19 2005 EDT
&gt; SMART support is: Available - device has SMART capability.
&gt; SMART support is: Enabled
&gt; 
&gt; === START OF READ SMART DATA SECTION ===
&gt; SMART overall-health self-assessment test result: PASSED
&gt; 
&gt; General SMART Values:
&gt; Offline data collection status:  (0x82) Offline data collection activity
&gt;                                         was completed without error.
&gt;                                         Auto Offline Data Collection:
&gt; Enabled.
&gt; Self-test execution status:      (   0) The previous self-test routine
&gt; completed
&gt;                                         without error or no self-test has
&gt; ever
&gt;                                         been run.
&gt; Total time to complete Offline
&gt; data collection:                 ( 430) seconds.
&gt; Offline data collection
&gt; capabilities:                    (0x5b) SMART execute Offline immediate.
&gt;                                         Auto Offline data collection
&gt; on/off support.
&gt;                                         Suspend Offline collection upon new
&gt;                                         command.
&gt;                                         Offline surface scan supported.
&gt;                                         Self-test supported.
&gt;                                         No Conveyance Self-test supported.
&gt;                                         Selective Self-test supported.
&gt; SMART capabilities:            (0x0003) Saves SMART data before entering
&gt;                                         power-saving mode.
&gt;                                         Supports SMART auto save timer.
&gt; Error logging capability:        (0x01) Error logging supported.
&gt;                                         General Purpose Logging supported.
&gt; Short self-test routine
&gt; recommended polling time:        (   1) minutes.
&gt; Extended self-test routine
&gt; recommended polling time:        (  85) minutes.
&gt; 
&gt; SMART Attributes Data Structure revision number: 10
&gt; Vendor Specific SMART Attributes with Thresholds:
&gt; ID# ATTRIBUTE_NAME          FLAG     VALUE WORST THRESH TYPE      UPDATED 
&gt; WHEN_FAILED RAW_VALUE
&gt;   1 Raw_Read_Error_Rate     0x000f   068   062   006    Pre-fail  Always  
&gt;     -       109071597


ERRORS!!!!!


&gt;   3 Spin_Up_Time            0x0003   096   096   000    Pre-fail  Always  
&gt;     -       0
&gt;   4 Start_Stop_Count        0x0032   100   100   020    Old_age   Always  
&gt;     -       0
&gt;   5 Reallocated_Sector_Ct   0x0033   100   100   036    Pre-fail  Always  
&gt;     -       0
&gt;   7 Seek_Error_Rate         0x000f   066   060   030    Pre-fail  Always  
&gt;     -       4123130


THESE ARE WHAT YOU'VE BEEN SEEING


&gt;   9 Power_On_Hours          0x0032   100   100   000    Old_age   Always  
&gt;     -       543
&gt;  10 Spin_Retry_Count        0x0013   100   100   097    Pre-fail  Always  
&gt;     -       0
&gt;  12 Power_Cycle_Count       0x0032   100   100   020    Old_age   Always  
&gt;     -       21
&gt; 194 Temperature_Celsius     0x0022   037   040   000    Old_age   Always  
&gt;     -       37
&gt; 195 Hardware_ECC_Recovered  0x001a   068   062   000    Old_age   Always  
&gt;     -       109071597


The error correction is being used heavily to make up for the short
comings of the drive.

&gt; 197 Current_Pending_Sector  0x0012   100   100   000    Old_age   Always  
&gt;     -       0
&gt; 198 Offline_Uncorrectable   0x0010   100   100   000    Old_age   Offline 
&gt;     -       0
&gt; 199 UDMA_CRC_Error_Count    0x003e   200   200   000    Old_age   Always  
&gt;     -       0
&gt; 200 Multi_Zone_Error_Rate   0x0000   100   253   000    Old_age   Offline 
&gt;     -       0
&gt; 202 TA_Increase_Count       0x0032   100   253   000    Old_age   Always  
&gt;     -       0
&gt; 
&gt; SMART Error Log Version: 1
&gt; ATA Error Count: 1
&gt;         CR = Command Register [HEX]
&gt;         FR = Features Register [HEX]
&gt;         SC = Sector Count Register [HEX]
&gt;         SN = Sector Number Register [HEX]
&gt;         CL = Cylinder Low Register [HEX]
&gt;         CH = Cylinder High Register [HEX]
&gt;         DH = Device/Head Register [HEX]
&gt;         DC = Device Command Register [HEX]
&gt;         ER = Error register [HEX]
&gt;         ST = Status register [HEX]
&gt; Powered_Up_Time is measured from power on, and printed as
&gt; DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes,
&gt; SS=sec, and sss=millisec. It &quot;wraps&quot; after 49.710 days.
&gt; 
&gt; Error 1 occurred at disk power-on lifetime: 519 hours (21 days + 15 hours)
&gt;   When the command that caused the error occurred, the device was active
&gt; or idle.
&gt; 
&gt;   After command completion occurred, registers were:
&gt;   ER ST SC SN CL CH DH
&gt;   -- -- -- -- -- -- --
&gt;   40 51 08 32 ec 12 e0  Error: UNC 8 sectors at LBA = 0x0012ec32 = 1240114
&gt; 
&gt;   Commands leading to the command that caused the error were:
&gt;   CR FR SC SN CL CH DH DC   Powered_Up_Time  Command/Feature_Name
&gt;   -- -- -- -- -- -- -- --  ----------------  --------------------
&gt;   25 00 08 32 ec 12 e0 00      18:59:19.206  READ DMA EXT
&gt;   35 00 08 fa 36 f9 e0 00      18:59:18.933  WRITE DMA EXT
&gt;   35 00 08 fa 14 fe e0 00      18:59:18.912  WRITE DMA EXT
&gt;   35 00 88 72 14 fe e0 00      18:59:18.909  WRITE DMA EXT
&gt;   35 00 08 0a c8 bf e0 00      18:59:18.892  WRITE DMA EXT
&gt; 
&gt; SMART Self-test log structure revision number 1
&gt; Num  Test_Description    Status                  Remaining 
&gt; LifeTime(hours)  LBA_of_first_error
&gt; # 1  Short offline       Completed without error       00%       540      
&gt;   -
&gt; 
&gt; SMART Selective self-test log data structure revision number 1
&gt;  SPAN  MIN_LBA  MAX_LBA  CURRENT_TEST_STATUS
&gt;     1        0        0  Not_testing
&gt;     2        0        0  Not_testing
&gt;     3        0        0  Not_testing
&gt;     4        0        0  Not_testing
&gt;     5        0        0  Not_testing
&gt; Selective self-test flags (0x0):
&gt;   After scanning selected spans, do NOT read-scan remainder of disk.
&gt; If Selective self-test is pending on power-up, resume after 0 minute delay.
&gt; 
&gt; 
&gt; 
&gt; _______________________________________________
&gt; Ale mailing list
&gt; Ale at ale.org
&gt; <a  rel="nofollow" href="http://www.ale.org/mailman/listinfo/ale";>http://www.ale.org/mailman/listinfo/ale</a>
-- 
James P. Kinney III          \Changing the mobile computing world/
CEO &amp; Director of Engineering \          one Linux user         /
Local Net Solutions,LLC        \           at a time.          /
770-493-8244                    \.___________________________./
<a  rel="nofollow" href="http://www.localnetsolutions.com";>http://www.localnetsolutions.com</a>

GPG ID: 829C6CA7 James P. Kinney III (M.S. Physics)
&lt;jkinney at localnetsolutions.com&gt;
Fingerprint = 3C9E 6366 54FC A3FE BA4D 0659 6190 ADC3 829C 6CA7
-------------- next part --------------
A non-text attachment was scrubbed...
Name: not available
Type: application/pgp-signature
Size: 189 bytes
Desc: This is a digitally signed message part



</pre>
<!--X-Body-of-Message-End-->
<!--X-MsgBody-End-->
<!--X-Follow-Ups-->
<hr>
<ul><li><strong>Follow-Ups</strong>:
<ul>
<li><strong><a name="00237" href="msg00237.html">[ale] harddrive errors</a></strong>
<ul><li><em>From:</em> jb at sourceillustrated.com (John Wells)</li></ul></li>
<li><strong><a name="00268" href="msg00268.html">[ale] harddrive errors</a></strong>
<ul><li><em>From:</em> jb at sourceillustrated.com (John Wells)</li></ul></li>
</ul></li></ul>
<!--X-Follow-Ups-End-->
<!--X-References-->
<ul><li><strong>References</strong>:
<ul>
<li><strong><a name="00205" href="msg00205.html">[ale] harddrive errors</a></strong>
<ul><li><em>From:</em> jb at sourceillustrated.com (John Wells)</li></ul></li>
<li><strong><a name="00211" href="msg00211.html">[ale] harddrive errors</a></strong>
<ul><li><em>From:</em> jimmyc at speedfactory.net (Jim Philips)</li></ul></li>
<li><strong><a name="00217" href="msg00217.html">[ale] harddrive errors</a></strong>
<ul><li><em>From:</em> jb at sourceillustrated.com (John Wells)</li></ul></li>
</ul></li></ul>
<!--X-References-End-->
<!--X-BotPNI-->
<ul>
<li>Prev by Date:
<strong><a href="msg00220.html">[ale] Bluetooth devices</a></strong>
</li>
<li>Next by Date:
<strong><a href="msg00222.html">[ale] Bluetooth devices</a></strong>
</li>
<li>Previous by thread:
<strong><a href="msg00217.html">[ale] harddrive errors</a></strong>
</li>
<li>Next by thread:
<strong><a href="msg00237.html">[ale] harddrive errors</a></strong>
</li>
<li>Index(es):
<ul>
<li><a href="maillist.html#00221"><strong>Date</strong></a></li>
<li><a href="threads.html#00221"><strong>Thread</strong></a></li>
</ul>
</li>
</ul>

<!--X-BotPNI-End-->
<!--X-User-Footer-->
<!--X-User-Footer-End-->
</body>
</html>