[no subject]

One of the biggest scams on EBay is "new" batteries for power supplies.
The only way to tell is to do some serious charging circuit monitoring
with manufacturing specs to compare with.

On Sun, 2005-12-18 at 21:18 -0500, Van Loggins wrote:
> My current UPS which is a APC Smart-UPS 1000. It started intermittantly 
> beeping a while back and after reading the online manual from APC
> I determined that the beeps were because the batteries were dying and 
> that I needed to replace them. I found replacement batteries for it
> on ebay and bought them.
> 
> To make a long story short, this didn't fix the problem, in fact it got 
> worse. The unit started beeping nonstop and would shut itself off and
> then wait for a minute or so and turn itself back on only to start 
> beeping again, and the unit doesn't keep running if the power is pulled 
> even though the charge meter is at 100% for the batteries.
> 
> 
> I'm no expert but I think this means that the the unit is pretty well 
> shot, and now I am stuck with two "Brand New" 12 volt 12 amp hour gel 
> lead acid batteries. I am looking at a APC Smart-UPS 700
> that I have the chance to get, but it needs batteries and after checking 
> into it, I found out that this model needs 12 volt 7 amp hour gel lead 
> acid batteries.
> 
> My question is this, would I be able to use the new batteries that I 
> just bought for my now defunct APC Smart-UPS 1000 in the APC Smart-UPS 
> 700 that I'm looking at buying?
> 
> in summary the old unit I had uses 12 volt 12 amp hour batteries, and 
> the replacement unit I am looking at uses 12 volt 7 amp hour batteries. 
> They look to be approximately the same size and hook up the same way.
> 
> Thanks for any info that you guys can pass along.
> 
> Merry Christmas to everyone!!!
> 
> Van
> 
> _______________________________________________
> Ale mailing list
> Ale at ale.org
&gt; <a  rel="nofollow" href="http://www.ale.org/mailman/listinfo/ale";>http://www.ale.org/mailman/listinfo/ale</a>
-- 
James P. Kinney III          \Changing the mobile computing world/
CEO &amp; Director of Engineering \          one Linux user         /
Local Net Solutions,LLC        \           at a time.          /
770-493-8244                    \.___________________________./
<a  rel="nofollow" href="http://www.localnetsolutions.com";>http://www.localnetsolutions.com</a>

GPG ID: 829C6CA7 James P. Kinney III (M.S. Physics)
&lt;jkinney at localnetsolutions.com&gt;
Fingerprint = 3C9E 6366 54FC A3FE BA4D 0659 6190 ADC3 829C 6CA7
-------------- next part --------------
A non-text attachment was scrubbed...
Name: not available
Type: application/pgp-signature
Size: 189 bytes
Desc: This is a digitally signed message part



</pre>
<!--X-Body-of-Message-End-->
<!--X-MsgBody-End-->
<!--X-Follow-Ups-->
<hr>
<ul><li><strong>Follow-Ups</strong>:
<ul>
<li><strong><a name="00260" href="msg00260.html">[ale] OT: question about replacing batteries in a APC UPS</a></strong>
<ul><li><em>From:</em> vanloggins at gmail.com (Van Loggins)</li></ul></li>
</ul></li></ul>
<!--X-Follow-Ups-End-->
<!--X-References-->
<ul><li><strong>References</strong>:
<ul>
<li><strong><a name="00251" href="msg00251.html">[ale] OT: question about replacing batteries in a APC UPS</a></strong>
<ul><li><em>From:</em> vanloggins at gmail.com (Van Loggins)</li></ul></li>
</ul></li></ul>
<!--X-References-End-->
<!--X-BotPNI-->
<ul>
<li>Prev by Date:
<strong><a href="msg00258.html">[ale] OT: question about replacing batteries in a APC UPS</a></strong>
</li>
<li>Next by Date:
<strong><a href="msg00260.html">[ale] OT: question about replacing batteries in a APC UPS</a></strong>
</li>
<li>Previous by thread:
<strong><a href="msg00324.html">[ale] OT: question about replacing batteries in a APC UPS</a></strong>
</li>
<li>Next by thread:
<strong><a href="msg00260.html">[ale] OT: question about replacing batteries in a APC UPS</a></strong>
</li>
<li>Index(es):
<ul>
<li><a href="maillist.html#00259"><strong>Date</strong></a></li>
<li><a href="threads.html#00259"><strong>Thread</strong></a></li>
</ul>
</li>
</ul>

<!--X-BotPNI-End-->
<!--X-User-Footer-->
<!--X-User-Footer-End-->
</body>
</html>