[no subject]

> That doesn't work since there is no module to mount the drive.  I have to
> provide that.  I just wondered if mixing SATA and IDE was not going to work. 
> Dell wouldn't sell a mixed machine so when it didn't have the module needed
> then I wondered.  Just checking before I go to the trouble.
> Dow


I must be misunderstanding your problem.  You have a machine w/SATA and IDE, 
running RHEL3 on the SATA drives.  The kernel doesn't require any special 
drivers/modules for the EIDE drives..only for the SATA ones.

Have you tried this yet?
-- 
Jonathan Glass, RHCE, MCP, Security+, Linux+, Network+, A+
System Support Specialist II
Institute for Bioengineering and Bioscience
315 Ferst Drive NW
Atlanta, Georgia 30332-0363
Office: 404-385-0127
Cell: 404-444-4086

-------------------------------------------------
This mail sent through IMP: <a  rel="nofollow" href="http://horde.org/imp/";>http://horde.org/imp/</a>


</pre>
<!--X-Body-of-Message-End-->
<!--X-MsgBody-End-->
<!--X-Follow-Ups-->
<hr>
<ul><li><strong>Follow-Ups</strong>:
<ul>
<li><strong><a name="00803" href="msg00803.html">[ale] Mixing SATA and IDE?</a></strong>
<ul><li><em>From:</em> Dow.Hurst at mindspring.com (Dow Hurst)</li></ul></li>
</ul></li></ul>
<!--X-Follow-Ups-End-->
<!--X-References-->
<ul><li><strong>References</strong>:
<ul>
<li><strong><a name="00799" href="msg00799.html">[ale] Mixing SATA and IDE?</a></strong>
<ul><li><em>From:</em> dhurst at mindspring.com (Dow_Hurst)</li></ul></li>
</ul></li></ul>
<!--X-References-End-->
<!--X-BotPNI-->
<ul>
<li>Prev by Date:
<strong><a href="msg00799.html">[ale] Mixing SATA and IDE?</a></strong>
</li>
<li>Next by Date:
<strong><a href="msg00801.html">[ale] SMC2402W</a></strong>
</li>
<li>Previous by thread:
<strong><a href="msg00799.html">[ale] Mixing SATA and IDE?</a></strong>
</li>
<li>Next by thread:
<strong><a href="msg00803.html">[ale] Mixing SATA and IDE?</a></strong>
</li>
<li>Index(es):
<ul>
<li><a href="maillist.html#00800"><strong>Date</strong></a></li>
<li><a href="threads.html#00800"><strong>Thread</strong></a></li>
</ul>
</li>
</ul>

<!--X-BotPNI-End-->
<!--X-User-Footer-->
<!--X-User-Footer-End-->
</body>
</html>